Etronix

Etronix Glow Charging Cable 4mm Banana Bullet Plugs ET0267 nitro ignitor starter

(No reviews yet) Write a Review

SKU:: ET0267
UPC:: 5055323921964
MPN:

On Sale

MSRP: $2.61

Now: $2.48

Was: $2.61

— You save $0.13

Current Stock: 10

Quantity:

Description
0 Reviews

Description

Additional Information -

ETRONIX GLOW CHARGING CABLE WITH BANANA PLUGS

Cable length is 160mm excluding connectors.

4mm Bannana bullet plug to connect to a charger

Avilable in 18AWG with male XT30, XT60, XT90, EC3, EC5, Tamiya, Deans, 4mm Bullet / bannana.

Available with thinner wire as Glow ignitor starterm, JST, RX Futaba, and Crocodile.

To use an RC glow charging cable, connect the plug on the cable to the glow plug in your RC engine, then plug the other end of the cable into a dedicated glow plug charger, ensuring the polarity is correct; once plugged in, turn on the charger to heat the glow plug for a set duration before attempting to start your engine; always follow the instructions on your specific charger and glow plug for proper usage.

Key points to remember:

Polarity is crucial:
Make sure the positive and negative connections on the cable match the polarity of your glow plug and charger
Charging time:
Most glow plug chargers have a built-in timer to control how long the glow plug heats up; consult your charger's manual for the appropriate time based on your engine and fuel type.
Glow plug removal:
Before connecting the charging cable, remove the glow plug from the engine to ensure proper heating and avoid damage.